Abstract
In the present study, the authors explored the viability of dry-spinning to produce cellulose nanocrystal (CNC) and polylactic acid composite fibers from dimethylformamide solutions. Fiber surface morphology, crystallinity and mechanical properties were assessed for fibers with 0, 1, 3 and 5 wt% CNCs. The fiber morphology transitioned from smooth to sharkskin to severe melt fracture with increasing extrusion speed. Surface morphology appeared to be weakly dependent on CNC content and addition of CNCs did not reduce melt fracture. Addition of 1 wt% CNC resulted in the highest crystallinity, an approximately 30% increase for the dry-spun composite fibers. Fibers exhibited a mixture of ductile and brittle-like behavior during mechanical testing. The elastic modulus and strength at failure were measured for three fiber diameter ranges and for increasing CNC content. A maximum average elastic modulus of 6·5 GPa and 100 MPa increase in strength at failure are reported for dry-spun composite fibers.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
