Abstract

In several countries, the wind power penetration increased tremendously in recent years. To ensure the proper functioning of the power system, some grid operators already require the capability to provide inertial response or primary control with wind turbines. This paper discusses the emulated inertial response with wind turbines by means of the synthetic inertia and the droop control strategy. The behavior of the synthetic inertia strategy is determined by the inertial and the droop constant, whereas droop control only has a droop constant. When these strategies are used, it is important to tune the control parameters depending on the power system to which the wind turbines are connected. Simulations show that it is possible to enhance but also to deteriorate the frequency response of the system, dependent on these parameters. For different power system compositions, the optimal inertial constant is always close to zero. This way, the synthetic inertia strategy reduces to a fast droop control strategy. This is an important outcome, as it means that no differentiation of the frequency is needed to obtain an optimal inertial response from the wind turbines, which is beneficial in terms of robustness. Consequently, droop control is a viable alternative for the synthetic inertia.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.