Abstract
This paper aims at reporting the results of a number of drag pick cutting tests on selected igneous rock samples to compare the experimentally determined maximum cutting force (FC′) values with theoretically estimated ones. First, a review on theoretical rock cutting models proposed for both chisel and conical picks was presented in detail. Experimental study consists of both chisel and conical pick cutting tests in unrelieved (single-pick) cutting mode with varying cutting depths. FC′ values were determined from experimental results, and theoretical models were utilized to compute FC′ for all cutting conditions. Computed and experimentally determined FC′ data were then compared for a referenced cutting depth. It is shown that the theoretical models might overestimate or underestimate FC′ and cannot give reliable results. Finally, explanations for these mismatches were presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Rock Mechanics and Geotechnical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
