Abstract
This paper describes the general trends correlating mechanical and corrosion properties with chemical composition of some Al-Fe-Si and Al-Fe-Mn-Si alloys for foils. These Al-rich eutectic alloys based on Al-Fe-Si and Al-Fe-Mn, when roll cast and appropriately processed to give fine and regular dispersion of intemetallic particles, can provide good combinations of strength and ductility. These characteristics have been responsible for the alloy success in replacing commercially pure (CP) aluminum for applications in thin sheet and foil gauges. The objective was to obtain an opinion about the possible role of alloying elements in corrosion behavior and mechanical properties of these commercial materials produced by cold rolling of twin roll cast strips.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
