Abstract

A data-driven clustering algorithm based on proper orthogonal decomposition was applied to assess the scatter found in the UH-60A wind tunnel airloads measurements. Upon verifying the capability of the algorithm, pushrod loads, blade surface pressure, sectional loads, and torsional moments were analyzed. Spatial eigenmodes resulting from the decomposition provided the optimal basis; projection of the individual cycles on to the high singular value modes allowed visualizing the statistical distribution of data over the entire azimuth. While not all cases showed furcation in the data, bimodal distribution was found in the high thrust cases, where statistically normal distribution is generally assumed. Consequent clustering of the measured cycles produced excellent correlation among clusters found in the pushrod loads, blade surface pressure, and torsional moment that suggest a common source for furcation in the data. The cycles assigned to one group repeatedly showed distinguishable variations from the other group in terms of the presence/absence of a dynamic stall vortex, azimuthal occurrence of stall, chordwise location of separation and reattachment etc. When one of the cluster is smaller in size compared to the other, the conventional phase-average obscured all the intricate features even when the loads are substantially higher than the larger cluster. In general, clustering the data set when warranted showed not only higher peak loads but also lower variance for both the clusters across the entire azimuth compared to the conventional simple phase-average results. Computational simulations were conducted using CREATETM-AV Helios towards understanding the underlying flow field. Misjudged earlier as under/over-predictive when compared with the simple phase-average data, Helios results consistently showed significantly improved correlation with the smaller of the two clusters. Combining the clustered results and the flow visualization provided by Helios, aperiodicity in the spatial location and the strength of both the trim tab vortices and tip vortices have also been hypothesized as potential sources of furcation.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.