Abstract

Abstract Dissimilar friction stir welding (FSW) of heat (AA 6082-T6) and non-heat (AA 5754-H22) treatable aluminium alloys, in lap joint configuration, was performed in this work. The base material plates were 1 mm thick. Welds were performed combining different plates positioning, relative to the tool shoulder, in order to assess the influence of base materials properties on welds strength. Three different tools were tested, one cylindrical and two conical, with different taper angles. Welds strength was characterized by performing transverse and tensile–shear tests. Strain data acquisition by Digital Image Correlation (DIC) was used to determine local weld properties. The results obtained enabled to conclude that the dissimilar welds strength is strongly dependent on the presence of the well-known hooking defect and that the hooking characteristics are strongly conditioned by base materials properties/positioning. By placing the AA 6082-T6 alloy, as top plate, in contact with the tool shoulder, superior weld properties are achieved independently of the tool geometry. It is also concluded that the use of unthreaded conical pin tools, with a low shoulder/pin diameter relation, is the most suitable solution for the production of welds with similar strengths for advancing and retreating sides.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.