Abstract
A direct punching of inclined ultra-high strength steel sheets having low ductility was carried out to improve the quality of the sheared edge. In the direct punching of an inclined sheet, the contact between the sheet and punch became gradual because of touch from the bottom edge of the punch, and thus the sheared portion tended to bend in the latter half of punching. As the strength of the sheet increased, defects such as burr and secondary burnished surface were occurred around the sheared edge due to the low ductility. The range of direct punching for sheared edge without defects was shown for the high strength steel sheets. To prevent the occurrence of defects, a punch having inclined bottom was used. In this punch, the contact with the sheet was changed, the uniform contact with the inclined bottom was given. In the punch having the inclined bottom, the secondary burnished surface in the edge of 980 MPa grade steel sheet was prevented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.