Abstract

The oxidation behaviour of Ni8Al and Ni25Cr coatings produced by high velocity oxygen fuel spray (HVOF) which were deposited on Fe-based alloys (CB2) was investigated. We simulated the service environment of the steam generator unit, and put the samples in a thermostatic tube furnace at 650[Formula: see text] in air with 20 wt.% water vapor for 1000 hours of cyclic oxidation. The formation mechanism are explained using SEM, XRD, and EDX. There were no spallations and obvious cracks in both coatings. Ni25Cr coating generated a better protection oxides scale than that scale on Ni8Al. The behavior and mechanism of the oxide scale formation had an important influence in coatings and we have discussed these phenomenons in the study.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.