Development of Wet Chemical Analysis Technique for Tramp Elements (M = As, Pb, Sb, and Sn) in Silver-M Alloys

Abstract

Wet chemical analysis techniques for four elements (M = As, Pb, Sb, and Sn) in Ag – M binary alloys were investigated with emphasis on the choice of solvent acid and the characteristic wavelength used in the ICP-AES (Inductively-Coupled Plasma Atomic Emission Spectrometer) analysis. The elements are representative tramp elements in ferrous scrap. The activity of these elements needs to be increased to remove them efficiently during the molten scrap refining process. The activity of these elements in the molten scrap (molten iron alloy) is usually measured by a chemical equilibration technique with molten Ag. Therefore, performing an accurate and reliable chemical analysis of these elements in the molten iron alloy and the molten Ag alloy is important. Preliminary tests using conventional acids (hydrochloric acid, nitric acid) resulted in unreliable results. In the present study, the proper choice of acids as solvents was investigated for each element M in the Ag-M alloys. Several synthesized Ag-M alloys of known compositions were analyzed using two ICP-AES systems independently, for cross-checking. As and Pb in Ag alloys could be successfully dissolved in the nitric acid-based solution. On the other hand, Sb and Sn in Ag alloys did not dissolve in the nitric acid-based solution completely, leaving some precipitates. It was found that the addition of hydrofluoric acid could resolve this problem. In addition to this, the effect of the mass of the Ag-M alloy and wavelength selection during ICP-AES analysis on the accuracy and the reproducibility were investigated. An optimized procedure for the wet chemical analysis of these elements in Ag-M alloys is reported.