Abstract
Plate bending is one of the most difficult techniques in shipbuilding and many investigations into the associated problems have been carried out. In this paper, associated problems have been carried out. In this paper, the development of a simulator for plate bending by line-heating is proposed. The simulation is based on a simplified non-linear elastic plate bending model. It was found that much improvement to the system was required. In-plane shrinkage was introduced, to select the best restraint conditions in FEM numerical calculation, and to construct an improved interface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Society of Naval Architects of Japan
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
