Abstract

An industrial computed tomography (CT) using the plastic scintillator (PS) as a detector sensitive to the radiation interaction position was proposed. Firstly, a code using Monte Carlo method was developed to study the effects of the plastic scintillator geometry in its gamma ray detection. The software simulates the results system designed with two photomultiplier-tubes set up in coincidence. Four simulations sets were performed to foresee the effect of the diameter (5-50 cm) and length (1-128 cm) of the detectors. The plastic scintillator was designed to be used for the industrial tomography system application. The Monte Carlo developed code was validated for its use to foresee the suitable dimension of the scintillator detector and some geometrical aspects

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.