Abstract
In recent years, piezoelectric fans and their feasibility for use in cooling electronic devices have been widely studied. However, there are few studies that address using a single piezoelectric actuator to generate radial air flow. In this study, a radial-flow multiple fan system (RMFS) was developed for the thermal management of high power LEDs. This system only used one piezoelectric actuator and a magnetic repulsive force to activate up to 20 fans, which featured low power consumption and a large cooling area. The RMFS was mounted in a circular heat sink to evaluate its thermal performance. To find the optimal design for the RMFS, the influence of some geometric parameters was investigated. The performance of different designs was compared with a commercially available axial fan. The results showed that design E had the best thermal performance among the designs because of its relatively large frequency and amplitude. The thermal resistance and percentage improvement under a 35W heat flux were 0.86K/W and 36.9%, respectively. In addition, a coefficient of performance (COP) was defined. The COP of design E was approximately 3.7 times that of the rotary fan. For the power consumption aspect, the RMFS is more efficient than the rotary fan.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Communications in Heat and Mass Transfer
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
