Abstract
The objective of this study is to use wheat flour (WF) and hydroxymethyl melamine prepolymer (HMP) to develop a low cost, highly water-resistant, starch-based bio-adhesive for plywood fabrication. Three-layer plywood was fabricated using the resultant adhesive, and the wet shear strength of the plywood samples was measured under various conditions. After determining that water resistance was significantly improved with the addition of HMP, we evaluated the physical characteristics of the starch-based adhesive and functional groups and analyzed the thermal stability and fracture surface of the cured adhesive samples. Results showed that by adding 20 wt.% HMP into WF adhesive, the sedimentation volume in the resultant adhesive decreased by 11.3%, indicating that the increase of crosslinking in the structure of the adhesives increased the bond strength, and the wet shear strength of the resultant plywood in 63 °C water improved by 375% when compared with the WF adhesive. After increasing the addition of HMP to 40 wt.%, the wet shear strength of the resultant plywood in 100 °C water changed from 0 MPa to 0.71 MPa, which meets the exterior use plywood requirement. This water resistance and bond strength improvement resulted from (1) HMP reacting with functions in WF and forming a crosslinking structure to prevent moisture intrusion; and (2) HMP self-crosslinking and combining with crosslinked WF to form a microphase separation crosslinking structure, which improved both the crosslinking density and the toughness of the adhesive, and subsequently, the adhesive’s bond performance. In addition, the microphase separation crosslinking structure had better thermostability and created a compact ductile fracture surface, which further improved the bond performance of the adhesive. Thus, using a prepolymer to form a microphase separation crosslinking structure within the adhesive improves the rigidity, toughness, and water resistance of the material in a practical and cost-effective manner.
Highlights
Starch is a renewable, natural polymer that is inexpensive, non–toxic, biodegradable, and has adhesion and film-forming properties [1,2,3]
Note that hydroxymethyl melamine prepolymer (HMP) shows a peak at 2950 cm−1 that is not present in the melamine spectra; this is attributed to C–H stretching vibrations
(–NH2 ) and amino (–NH–) vibrations [31]; a methylene C–H bending vibration at 1485 cm−1 [32]; and a secondary amine C–N stretching at 1157 cm−1 [33]. All of these findings indicate that melamine reacted with formaldehyde to develop methylol melamine and these methylol melamine further formed a prepolymer with –NH–CH2 –NH– linkage by a self-condensation reaction (Figure 1b)
Summary
Natural polymer that is inexpensive, non–toxic, biodegradable, and has adhesion and film-forming properties [1,2,3]. Many researchers have attempted to modify the starch in order to improve the bond performance and/or water resistance of the resultant adhesive. Such attempts include, but are not limited to oxidized modification [7], enzymatic modification [8,9], esterified modification [10,11,12,13], and grafting modification [14,15]. In which a carboxyl, vinyl, and/or other high reactivity functional group is grafted onto the starch molecule, facilitates the formation of a crosslinking structure that improves bond strength and water resistance of the resultant adhesive [16].
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
