Development of a borehole stress meter for studying earthquake predictions and rock mechanics, and stress seismograms of the 2011 Tohoku earthquake (M 9.0)

Abstract

Although precursory signs of an earthquake can occur before the event, it is difficult to observe such signs with precision, especially on earth’s surface where artificial noise and other factors complicate signal detection. One possible solution to this problem is to install monitoring instruments into the deep bedrock where earthquakes are likely to begin. When evaluating earthquake occurrence, it is necessary to elucidate the processes of stress accumulation in a medium and then release as a fault (crack) is generated, and to do so, the stress must be observed continuously. However, continuous observations of stress have not been implemented yet for earthquake monitoring programs. Strain is a secondary physical quantity whose variation varies depending on the elastic coefficient of the medium, and it can yield potentially valuable information as well. This article describes the development of a borehole stress meter that is capable of recording both continuous stress and strain at a depth of about 1 km. Specifically, this paper introduces the design principles of the stress meter as well as its actual structure. It also describes a newly developed calibration procedure and the results obtained to date for stress and strain studies of deep boreholes at three locations in Japan. To show examples of the observations, records of stress seismic waveforms generated by the 2011 Tohoku earthquake (M 9.0) are presented. The results demonstrate that the stress meter data have sufficient precision and reliability.