Abstract
Purpose – The purpose of this paper is to determine the feasibility of identifying the creep rupture of reactor cladding tubes using acoustic emission technique (AET). Design/methodology/approach – The creep rupture tests were carried out by pressuring stainless steel capsules upto 6 MPa at room temperature and then heating continuously in a furnace upto rupture. The acoustic emission (AE) signals generated during the creep rupture tests were recorded using a 150 kHz resonant sensor and analysed using AE Win software. Findings – When rupture occurs in the pressurized capsule tube representing the cladding tube, AE sensor attached to a waveguide captures the mechanical disturbance from the capsule and these data can be advantageously used to identify the creep rupture event of the cladding tube. Practical implications – The creep rupture data of fuel clad tube is very important in design and for smooth operation of nuclear reactors without fuel pin failure in reactors. Originality/value – AE is an advanced non-destructive evaluation technique. This technique has been successfully applied for on-line monitoring of creep rupture of the reactor cladding tube which otherwise could be detected by thermocouple readings only.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.