Determination of the carbon isotopic composition of whole/intact biological specimens using at-line direct thermal desorption to effect thermally assisted hydrolysis/methylation

Abstract

In this paper, we discuss the use of a direct thermal desorption (DTD) interface as an alternative to Curie-point flash pyrolysis system as an inlet technique in gas chromatography–combustion isotope-ratio mass spectrometry (GC/C-IRMS) analysis of whole/intact phytoplankton and zooplankton specimens. The DTD in combination with a combipal auto-injector is programmed to perform the injection, evaporation of solvents, transport of capped programmed-temperature vaporizer (PTV) liners to the PTV injector and chemical derivatisation (thermally assisted hydrolysis/methylation; THM) such that a profile of a cellular fatty acids is obtained. Flow-cytometric sorted microalgae and handpicked zooplankton are used as samples with trimethylsulfonium hydroxide (TMSH) as methylating reagent. A major advantage of this novel approach over the Curie-point technique is the automation of the total procedure, which allows unattended analysis of large sample series. The profiles and δ 13C carbon isotopic signatures of the fatty acid methyl esters (FAMEs) produced are very similar to those obtained using the Curie-point flash pyrolysis method. It is shown that algal samples must be kept no longer than 48 h in the DTD sample tray prior to the THM-analysis in order to maintain the integrity of their FAME profile.