Abstract
A new portable sampling system was developed to extract Radium isotopes from large volumes (up to 300L) of fresh surface- and ground-waters of low Ra-activities (<5mBq/L). Ra is quantitatively adsorbed on a small amount (6.5g) of MnO2-coated acrylic fibers, which are then dried and burned at 600°C in the laboratory. The resulting Mn-oxide powder (about 2cm3 when compacted) is then analyzed through gamma-ray spectrometry which allows measurement of the whole Ra quartet (226Ra, 228Ra, 224Ra and 223Ra) in a single counting of a few days. The usual relative standard combined uncertainties (1σ) are 2–3% for 226Ra, 228Ra and 224Ra; and less than 10% for 223Ra. This method was applied to the analysis of Ra in karstic waters of the Lez aquifer, and surface- and ground-waters of the upper and middle Vidourle watershed (South of France). The analyzed waters have relatively low 226Ra activities (1–4mBq/L) in both cases, regardless of the contrasted geology (Mesozoic limestone vs crystalline Variscan basement), but clearly distinct (228Ra/226Ra) ratios in agreement with the differences in Th/U ratios of the two drained areas. Short-lived Ra isotopes (224Ra and 223Ra) appear to be mainly influenced by near-surface desorption/recoil processes for most of the sampling sites.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
