Abstract
A piezoelectric sensor and a pancake coil sensor were used for broadband detection of laser-induced ultrasound in single-crystal aluminum and polycrystalline nickel. Pressure pulses with pronounced compression phases were induced by laser pulses of 5 ns duration from one side of the specimens and detected from the opposite side. A coupling layer of water was required for the piezoelectric method, whereas the pancake coil placed in the biasing permanent field of a cylindrical magnet ~0.25 T allowed noncontact detection. The signals detected by a piezoelectric transducer showed bipolar form and their spectra covered the range from 5 to 90 MHz. The signal measured in aluminum by a pancake coil was assigned to the eddy current sources and had single polarity. The peak-to-peak value of the signal in nickel was higher and had bipolar form because of the inverse magnetostrictive effect. The high-frequency limit detected by the pancake coil approached 200 MHz.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.