Abstract
This article proposes a Rogowski switch-current sensor (RSCS) with the offset compensation for the current control of the three-phase SiC inverter. The RSCS is built into the four-layer print circuit board (PCB) gate drive board. The coil parameters are analyzed with the Ansys software (Maxwell and Q3D) and then compared with the measurement results. The analog signal processing circuits are implemented with the operational amplifier (op amp) to reconstruct the switch current and the phase current. Unfortunately, the RSCS suffers from the op amp offset voltage and bias current integration, which varies according to the duty cycle and switching frequency. This article proposes an offset compensation software (S/W) to address this issue. Moreover, an <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">RC</i> discharge factor is proposed to make up for the discharging phenomenon of the capacitor in the integrator feedback path. A three-phase SiC inverter prototype is built and tested with the three-phase inductor load to verify the feasibility of the method. Experimental results at 10–30 kHz, 600 V, 150 A show the proposed method to have less than 2% sensing error.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
