Abstract
A method of plotting the deformation curve for the material of thin-film coatings using the parameters of the indentation diagram is considered. This method is based on solving the inverse problem of mechanics of continua. An algorithm is used for this purpose that combines a full-scale experiment and a numerical calculation. Data on the deformation curves for multicomponent nitride ((AlSi,Ti) and (AlSi,Cr)N) and carbide ((AlSi,Ti)–C:H, and (AlSi,Cr)–C:H) coatings are obtained and a comparative analysis of the properties of these coatings is carried out. Results of the numerical calculation of stresses that act during indentation are presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
