Abstract
Repetitive upsetting-extrusion (RUE) that was originally invented to process powder materials for bulk mechanical alloying is currently being used to process bulk materials. Bulk materials are subjected to severe plastic deformation using the same die design that was used to process powder materials. As the deformation behaviour of powder and bulk materials are quite different, it has to be evaluated whether a single die design is suitable to process both these materials. Further, information on the deformation behaviour and strain homogeneity that can be achieved by subjecting bulk materials to RUE process are also currently not available. To address these issues, both numerical analysis and actual experiments on commercial pure copper has been carried out. The results obtained are presented and discussed here
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.