Deformation and Simulation of the Cellular Structure of Foamed Polypropylene Composites.

Abstract

Foamed Polymer is an important polymer material, which is one of the most widely used polymer materials and plays a very important role in the polymer industry. In this work, foamed polypropylene (PP) composites are prepared by injection molding, and the cell deformation process within them is studied by combining visualization technology and COMSOL software simulation. The results shows that the deformation of isolated cells depends in temperature, and there is no macroscopic deformation. There was no significant difference between the stress around adjacent cells at different temperatures, but the stress at different positions around the adjacent cells has obvious changes, and the maximum stress at the center of the adjacent cells was 224.18 N·m-2, which was easy to cause a lateral deformation of the cells. With the increase in temperature, the displacement around the adjacent cell gradually increased, the maximum displacement of the upper and lower symmetrical points of the cell was 14.62 μm, which is most likely to cause longitudinal deformation of the cell; the deviation of the cell deformation parameter gradually increased, which led to deformation during the growth of the cell easily. The simulation results were consistent with the visualized cell deformation behaviors of the foamed PP composites.