Abstract
The paper presents the development of a decision algorithm for a prototype computer-aided process planning system IMOLD_CAPP for the manufacture of an injection mould. A combination of a generative and plan template approach is used for the development of the system. The input to the system is a 3D solid model developed using IMOLD TM . Successful implementation of the prototype IMOLD_CAPP depends on its incorporation to an appropriate machining algorithm. Unfortunately, there is no one standard algorithm to choose the appropriate machining process from high-speed machining (HSM), electrical discharge machining (EDM) or a combination of the two. Consequently, this research undertook the development of a decision algorithm for the selection of the appropriate machining process. The algorithm decides whether HSM, EDM or a combination should be chosen for a particular case. Several case studies are conducted and the economics of these processes have been analysed to verify the suitability of the algorithm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.