Cylindrical heterogeneous detonation waves

Abstract

Further experimental studies of blast wave initiated cylindrical heterogeneous (liquid fuel drops, gas oxidizer) detonation waves are described. A pie-shaped shock tube, used for these studies, was altered in certain ways so as to improve the modeling of cylindrical waves. These modifications, along with some operational aspects, are briefly discussed. The breech of the facility, where the blast wave is generated by an explosive, became distorted with usage. Results are presented which show that lower detonation velocities are realized with the damaged breech (other conditions being the same). A photographic and pressure switch wave time of arrival study was made to ascertain the wave shape. Photographs are shown which show that the waves, blast as well as detonation, are close to cylindrical. However, in some cases there is appreciable distortion of the wave front by debris ahead of the wave. Presumably this debris comes from the blasting cap used to ignite the condensed explosive. A series of experiments was conducted using kerosene drops of 388 μm diameter dispersed in air through use of a large number of hypodermic needles. Radial fuel void regions were established by cutting off the fuel flow to a number of needles. Preliminary results relating to the effect of the size of the cloud gap on detonation velocity, quenching, and the initiator energy levels required for detonation are discussed.