Abstract
The aim of this study was to investigate the cutting ability of retro tips powered by a sonic handpiece (MM 1500, Micro Mega, Prodonta, Geneva, Switzerland). Two levels of the following variables were evaluated in this study: a) power setting with the an inlet ring half or fully open, b) orientation of tip perpendicular or parallel to the long axis of the handpiece, c) length of tip 2 or 3 min, d) loading of 25 or 50 grams, e) tip size 35 or 55. The substrate used was 1 mm thick sections of bovine bone and load was controlled by using a load cell interfaced with a transducer meter. Instrumentation time was fixed at 10 seconds with water irrigation. A 2(5) full factorial analysis was performed with two replications making a total of 64 experimental units. The resultant depth of cut was measured using a stereo microscope at x50 magnification. Analysis of the data indicated that all variables had a significant effect on cutting (ANOVA p < 0.05). The most significant factor was power, followed by tip length tip orientation, width and load. An increase in loading resulted in tip constraint and a reduction of cutting at the lower power setting. In conclusion sonically activated retro tips were found to cut satisfactorily with instrument air inlet ring opening/power having the main effect.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
