Abstract
We present the characteristics of uniformly doped silicon Esaki tunnel diodes grown by low temperature molecular beam epitaxy (T/sub growth/=275/spl deg/C) using in situ boron and phosphorus doping. The effects of ex situ thermal annealing are presented for temperatures between 640 and 800/spl deg/C. A maximum peak to valley current ratio (PVCR) of 1.47 was obtained at the optimum annealing temperature of 680/spl deg/C for 1 min. Peak and valley (excess) currents decreased more than two orders of magnitude as annealing temperatures and times were increased with rates empirically determined to have thermal activation energies of 2.2 and 2.4 eV respectively. The decrease in current density is attributed to widening of the tunneling barrier due to the diffusion of phosphorus and boron. A peak current density of 47 kA/cm/sup 2/ (PVCR=1.3) was achieved and is the highest reported current density for a Si-based Esaki diode (grown by either epitaxy or by alloying). The temperature dependence of the current voltage characteristics of a Si Esaki diode in the range from 4.2 to 325 K indicated that both the peak current and the excess current are dominated by quantum mechanical tunneling rather than by recombination. The temperature dependence of the peak and valley currents is due to the band gap dependence of the tunneling probability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
