Abstract
In a flip chip solder joint, the cross-section of the solder bump is one to two orders of magnitude bigger than that of an interconnect wire. At the contact interface between the bump and the wire, a very large current crowding occurs and it causes a unique and fast electromigration failure in the bump. Simulation of the current crowding phenomenon in a flip chip solder bump is reported here. Experimental results of real flip chip solder bumps show that void formation begins near the current crowding region of the contact, and after it is nucleated, it spreads quickly across the contact area. By designing the solder bump to achieve a uniform current distribution, we can improve its electromigration resistance and increase its current carrying capacity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.