Crack initiation in relation to the tool edge radius and cutting conditions in nanoscale cutting of silicon

Abstract

In cutting of brittle materials, experimentally it was observed that there is a ductile–brittle transition when the undeformed chip thickness is increased from smaller to larger than the tool cutting edge radius of the zero rake angle. However, how the crack is initiated in the ductile–brittle mode transition as the undeformed chip thickness is increased from smaller to larger than the tool cutting edge radius has not been fully understood. In this study, the crack initiation in the ductile–brittle mode transition as the undeformed chip thickness is increased from smaller to larger than the tool cutting edge radius has been simulated using the Molecular Dynamics (MD) method on nanoscale cutting of monocrystalline silicon with a non-zero edge radius tool, from which, for the first time, a peak deformation zone in the chip formation zone has been found in the transition from ductile mode to brittle mode cutting. The results show that as the undeformed chip thickness is larger than the cutting edge radius, in the chip formation zone there is a peak deformation depth in association with the connecting point of tool edge arc and the rake face, and there is a crack initiation zone in the undeformed workpiece next to the peak deformation zone, in which the material is tensile stressed and the tensile stress is perpendicular to the direction from the connecting point to the peak. As the undeformed chip thickness is smaller than the cutting edge radius, there is no deformation peak in the chip formation zone, and thus there is no crack initiation zone formed in the undeformed workpiece. This finding explains well the ductile–brittle transition as the undeformed chip thickness increases from smaller to larger than the tool cutting edge radius.