Coupled HTM modelling of cold water injection in fractured hydrocarbon reservoirs

Abstract

The Yucca Mountain Project is conducting a Single Heater Test (SHT) in the Exploratory Studies Facility at Yucca Mountain, NV to evaluate coupled thermal-mechanical-hydrologic-chemical processes in situ . This paper describes the thermomechanical aspects of the SHT and presents preliminary results from the test. The 5-m long heater deployed in the SHT was energized on 26 August 1996 with the heater power set at 4 kW. Thermomechanical instrumentation was installed within and on the rock mass surrounding the SHT. The thermomechanical instrumentation includes temperature measurements using thermocouples, RTDs, and thermistors; displacement measurements using multiple-point borehole extensometers (MPBXs), tape extensometers, and surface-mounted wire extensometers; load measurements from load cells on rock bolts installed both within thermally perturbed and ambient regions; and rock mass modulus measurements using the NX borehole jack. Pretest analyses of the thermomechanical response were conducted using the thermohydrologic code TOUGH2 and the thermomechanical structural code JAC3D. The test design, preliminary data, and comparisons between pretest predictions and early data from selected thermal and mechanical sensors are presented.