Cotransport of Titanium Dioxide and Fullerene Nanoparticles in Saturated Porous Media

Abstract

This study investigated the cotransport of titanium dioxide nanoparticles (nTiO2) and fullerene nanoparticles (nC60), two of the most widely utilized nanoparticles, in saturated quartz sand under a series of ionic strengths in NaCl solutions (0.1-10 mM) at both pH 5 and 7. Under all examined ionic strengths at pH 5, both breakthrough curves and retained profiles of nTiO2 in the copresence of nC60 were similar to those without nC60, indicating that nC60 nanoparticles copresent in suspensions did not significantly affect the transport and retention of nTiO2 in quartz sand at pH 5. In contrast, under all examined ionic strengths at pH 7, the breakthrough curves of nTiO2 in the copresence of nC60 in suspensions were higher and the retained profiles were lower than those without nC60, which demonstrated that the presence of nC60 in suspensions increased the rate of transport (decreased retention) of nTiO2 in quartz sand at pH 7. Competition of deposition sites on quartz sand surfaces by the copresence of nC60 was found to contribute to the increased nTiO2 transport at pH 7. Under all examined ionic strength conditions at both pH 5 and 7, the breakthrough curves of nC60 were reduced in the copresence of nTiO2, and the corresponding retained profiles were higher than those without nTiO2, indicating that the presence of nTiO2 decreased the transport of nC60 in quartz sand. Co-deposition of nC60 with nTiO2 in the form of nTiO2-nC60 clusters as well as the deposition of nC60 onto previously deposited nTiO2 were responsible for the increased nC60 deposition in the presence of nTiO2 at pH 5, whereas deposition of nC60 onto surfaces of predeposited nTiO2 was found to be responsible for the increased nC60 deposition at pH 7.