Abstract
This paper presents a new method of directly measuring the mass flow of gas using the well-known Coriolis principle, which has proved successful for mass flow measurement of liquids. The prototype consists of two U-shaped tubes, forming a device resembling very much a tuning fork, which is stimulated by electromagnetic actuators to perform autonomous bending oscillations. By this means the fluid is subjected to a radial velocity that, in combination with the axial velocity of the flow, induces harmonic Coriolis forces of the same frequency. This causes the U-shaped tube to perform torsional oscillations that superimpose on the bending oscillations. Both oscillations can be detected via electromagnetic transducers. The amplitude of the torsional oscillation induced by the Coriolis forces is very small as the density of gas is very low. It can be amplified by tuning the eigenfrequencies of torsion and bending in a control loop. This results in an amplification of the torsional amplitude by a factor of 10 2, allowing the mass flow of gas to be measured under normal conditions.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
