Abstract
This paper presents the functional characteristics of the line parameters based on the developed control software for speed, tension, regulation of traverse device for proper arrangement of the material on drum and temperature regulation. Speed and tension regulation is performed using the PLC controller S7 1500 series and conventional converters and inverters of the Sinamics DCM and G120 series. A control method was used where one device is the leader and all the others follow its speed with a given ratio and tensile control. Setting the parameters of conventional converters and inverters for controlling multi-motor drives was realized using the StartDrive tool. The temperature control of the extruder zones was done taking into account the mutual influence of the zones. Control and monitoring are implemented with software written in TIA Portal V15.1. software package.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IJEEC - INTERNATIONAL JOURNAL OF ELECTRICAL ENGINEERING AND COMPUTING
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
