Continuous production machine for separating and shaping Taiping Houkui tea.

Abstract

In response to the challenges of low automation and a lack of a continuous processing system for Taiping Houkui tea, this study proposed a design scheme for a continuous processing line and built a continuous processing prototype for testing by combining the production requirements of Taiping Houkui tea, the characteristics of withered leaves, and the existing relevant production equipment. First, the physical properties of Taiping Houkui tea were determined. A simulation was performed using the Hertz-Mindlin model, and the motion states of the tea leaves were obtained under different conditions to define the parameter design range of the experimental platform and verify its structural rationality. Then, the response surface methodology was used to optimize the working parameter ranges and obtain the best working parameters for the feeding and kneading mechanisms. Finally, a continuous production prototype was constructed for further production verification. The experimental results show that the success rate of continuous production on this platform was 70.68%, with an average output of approximately 0.4kg/h for Taiping Houkui dry tea on a single slide track, and the produced tea was similar to manually made tea. This demonstrates that the continuous production technique has high feasibility and provides a reference for continuous production of Taiping Houkui tea.