Continuous monitoring of heart failure biomarker using a sensitive graphene-based electrical sensor

Abstract

Abstract Heart Failure (HF) is a complex condition that imposes significant burdens on both patients and healthcare systems. The economic impact of HF therapy and management is substantial, underscoring the urgency for proactive measures to mitigate its development. Regular assessments play a pivotal role in identifying individuals at risk and initiating timely interventions to prevent or delay HF progression [1, 2]. NT-proBNP, an amine-terminated form of brain natriuretic peptide, emerges as a promising biomarker in the realm of chronic HF diagnosis, prognosis, and risk assessment [3]. Its utility lies in providing valuable insights into disease progression and prognosis. In recent years, biosensors based on Field Effect Transistors with Graphene (Gr) gate (GFET) have garnered attention for their rapid response, sensitivity, and on-chip integration [4]. Here, we present a sensitive miniaturized GFET sensor for continuous NT-proBNP measurement. The sensor is an array of GFET devices with sensing gates of a monolayer Gr decorated with aptamers as catch probes. Averaging over similar devices in an array approach ensures measurement consistency throughout the experiment. Moreover, the significant challenge posed by the Debye length in FET biosensors is effectively addressed through the functionalization with short folding aptamers [4]. The sensor is built based on a chip comprising an array of 28 individual micro GFETs (Fig. 1a). For the functionalization of Gr gates, we utilized 1-pyrene butyric acid N-hydroxysuccinimide ester as a linker between the aptamer probes and the Gr surface. Subsequently, the Gr surface was incubated with an amine-terminated aptamer solution (Fig. 1c). A schematic diagram of the sensory chip having a droplet of the sample is shown in Fig. 1b. To quantify NT-proBNP levels an 8µL droplet of the buffer solution containing a specific NT-proBNP concentration was deposited onto the sensor. The drain current (IDS) served as the sensor signal for each target concentration (Figs. 2a and 2b). The sensor signal decreased with increasing target concentration, while negligible response was observed when injecting blank buffers. This phenomenon can be attributed to the folding of aptamers upon binding to their target. Also, continuous measurement was conducted at a fixed gate voltage of 0.9V, recording the drain current while the target concentration gradually increased in the sample droplet. This process revealed a decrease in sensor current as we expected (Fig. 2c). The sensor exhibits remarkably low detection limits of 50 pg/mL and a linear range from 100 pg/mL to 10 ng/mL, which are highly conducive for early HF diagnosis and aligning well with reported NT-proBNP levels in patient biofluid [5]. The proposed sensor holds promise as a wearable device for continuous monitoring of high-risk patients. Additionally, this technology shows potential as a detection tool for acute heart failure in hospitalized patients.Sensor viewSensor responses