Continuous Deep Beams Behavior Under Static Loads: A Review Study

Abstract

Few studies discussed the continuous deep beams CDB behaviour in spite of its great importance in building constructions due to the usual use in bridges and tall buildings as a load distributer. The behaviour of CDB shows a different behaviour when comparing with the simply supported one, so the expected behaviour of SDB does not match with the CDB. So, this paper deals with reviewing the behaviour of CDB in the past researches. It has been concluded that, the CDB resist the applied loads by flexural and shear together, the flexural behaviour appears at the first loading stage then the beam start to resist by shear capacity. The amount of resistance of beam by flexural depends on a/h ratio, main and web steel reinforcement and concrete compressive strength. Flexural behaviour may not appear for very small a/h ratio or over main reinforcement. Also, main steel reinforcement at both top and bottom of beam does not reach to yielding point expected one case, which is, the main steel ratio is less than 0.6%, thereby, tie failure will governs.