Abstract
In this work, an H bridge was built and controlled to be used as a frequency variator in electromagnetic induction heating. Due different frequency values are required for this process depending on its diameter, it is necessary to adjust the pulse rate for each specific case. The H bridge was built using the N type MOSFET, model IRF640. Its driving capacity is 18 Ampere and it can operate at 200V. For its operation, the integrated circuit IR2110 was used, which can operate a MOSFETS or IGBTs bridge that works up to 500V. Pulse generation was performed with the Arduino board. As a result, a load frequency of 5 KHz was achieved, which is sufficient for use in induction heating of an inch diameter steel bar.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
