Abstract
Fine finishing of cylindrical internal surfaces without affecting geometric form is a critical requirement in several mechanical and aerospace applications. Although various methodologies using flexible abrasive media are reported for the same, many of them demand complex tooling and fixtures to be developed in tune with the internal dimensions to feed the abrasive media. The present paper investigates the feasibility of using magneto-elastic abrasive balls with the aid of a mechanically deployable tool for microfinishing of geometrically symmetric tubular specimens. The deployable tool used for the present experimentation is designed like an umbrella mechanism, with magnetic pads to hold the elastic abrasive balls, expandable for bore diameter ranges from 45 to 75 mm. The magnetic type elastic abrasive balls proposed in the form of mesoscale balls of diameter 3.5 ± 0.25 mm are capable of finishing the bore surface without altering its roundness. Effects of elastomeric medium, mechanics of material removal and generation of finished profile during the proposed technique have been discussed in detail, through a comprehensive mathematical model. Effect of various process variables on surface roughness was investigated experimentally using response surface methodology and the theoretical predictions were validated at optimum operating condition. Sixty-two percent reduction in average roughness on brass tubes of initial roughness 0.168 μm, with significant improvement in all the associated two-dimensional roughness parameters and without any deviation on roundness, was clearly demonstrating the potential of proposed methodology.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.