Abstract

Applying the computed software ANSYS, a 3D mathematical model of magnetic field inside the mold with FC-Mold was bewrited, in order to achieve the magnetic induction results inside the mold with the FC-Mold. The distribution features of magnetic induction results of liquid steel inside the mold with the FC-Mold was resolved and discussed. The explanation of simulation results was that the FC-Mold equipment can form a stabilizing magnetic field, the magnetic field inside the liquid steel had adequate intensity, this valid magnetic field engendered by the FC-Mold was imploded in the overlay region of magnetic pole mainly. The valid magnetic field enshrouded the region of total mold width. In the external part of the overlay region of magnetic pole, the magnetic induction intensity was slightly smaller. The magnetic intensity distribution was basically even toward the width and thickness directions of mold. Toward the direction of mold height, the magnetic intensity was appeared parabolic shape in the overlay region of magnetic pole, the two peaks of magnetic intensity appeared in the center of the overlay region of magnetic pole, and then it gradually declined from the mold top toward the mold bottom outside the overlay region of magnetic pole.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.