Abstract
Compression After Impact (CAI) strength is critical to the safety and weight of carbon fibre aircraft. In this paper, the standard aerospace industry practice of using separate analyses and tests for panel buckling and CAI strength is challenged. Composite panels with a range of stacking sequences were artificially delaminated and subject to compression testing in a fixture that allowed local sublaminate and global panel buckling modes to interact. Compared to panels without delamination, interaction of buckling modes reduced panel buckling strains by up to 29%. Similarly, compared to delaminated panels restrained against panel buckling, interaction reduced delamination propagation strains by up to 49%. These results are the first to indicate that restriction of interaction during CAI testing is unconservative and therefore potentially unsafe. A novel integration of an analytical Strip model, for sublaminate buckling driven delamination propagation, and a Shanley model, for determining increased local strain due to sublaminate-buckling-induced panel curvature, is used to calculate the reduction in strength due to buckling mode interaction. Assuming a typical sublaminate post to pre-buckling stiffness ratio of 0.65, the difference in integrated model and experimental results is<11% – a level of accuracy that will allow the integrated model to drive initial design studies.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.