Abstract
Systematic experimental work was conducted to investigate the solids acceleration length in a 0.10 m i. d., 16 m long circulating fluidized bed (CFB) riser with fluid catalytic cracking (FCC) particles over a wide range of operating conditions. A more feasible method is proposed to determine the acceleration length from the measured axial profiles of pressure gradient (or apparent solids holdup). With this new method and large amounts of experimental results, a clear picture of the variation of the acceleration length with both solids circulating rate and superficial gas velocity is obtained. It is found that the acceleration length increases generally with increasing solids flow rate and/or decreasing gas velocity. However, the particular variation patterns of the acceleration length with operating conditions are quite different in different operation ranges. Especially under the conditions near or at the accumulative choking, the acceleration length extends rapidly with increasing solids flow rate and/or decreasing gas velocity, and sometimes takes up the whole riser height. Reasonable explanations are provided for the observed variation patterns of the acceleration length.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
