Comprehensive study of plasma polymerization parameters on thiol-coated LDPE films for effective fibronectin adsorption targeting biomedical applications

Abstract

In the realm of biomedical applications, biocompatible materials with optimized surface properties are crucial for facilitating cellular interactions. To attain the perfect balance of these properties, surface modification of non-toxic and stable bulk materials is often required. Within this context, this research aimed to improve the physiochemical and cell-responsive properties of a low-density polyethylene film. This was achieved by depositing thiol-rich coatings using a dielectric barrier discharge plasma reactor operating at medium pressures, with 1-propanethiol serving as polymerization precursor. The study systematically investigated the impact of key plasma polymerization parameters, including DBD chamber pressure, treatment time, and the combination of precursor flow rate and discharge power represented by the Yasuda parameter, to identify optimal plasma processing conditions for the formation of thiol-rich coatings. To characterize the coating thickness, hydrophilicity and surface chemical composition, atomic force microscopy, water contact angle measurements, and X-ray photoelectron spectroscopy were employed. The findings indicated that reducing the chamber pressure to 10 kPa led to more hydrophilic and thicker deposits possessing a higher sulphur content. Deposition time (5 to 15 min) also significantly impacted coating thickness and surface chemistry, where long times increased thickness, but also led to a reduced sulphur and increased oxygen content because of more pronounced etching. The optimal deposition time was therefore set at 10 min resulting in the deposition of dense coatings possessing a high number of sulphur-containing functionalities. The Yasuda parameter (W/FM) analysis demonstrated optimal thiol incorporation in combination with high coating stability at an intermediate W/FM value of 72 MJ/kg. Following the determination of the optimal plasma polymerization parameters, the effectiveness of thiol plasma polymerization and subsequent fibronectin immobilization for enhancing cell adhesion and proliferation was investigated. The thiol-coated substrates were found to exhibit superior protein immobilization, because of the high affinity for protein binding of the available thiol groups. To assess cellular responses, Schwann cells were cultured on uncoated and coated samples before and after fibronectin immobilization. The results revealed a superior cellular response of the thiol-coated samples after fibronectin immobilization, showing the highest cell viability and significantly enhanced cell adhesion and proliferation. Collectively, these results underscore the synergistic effect of thiol plasma polymerization and fibronectin immobilization in promoting the cellular response of LDPE substrates, thus highlighting their potential as a surface modification strategy of biomaterials.