Abstract
In this study, the treatment of the effluents of an artisanal tannery by electrocoagulation with iron electrodes was carried out. During electrolytic treatment, a current intensity of 0.4 A was used, and the electrolysis time was varied from 0 to 40 minutes. The performance of electrocoagulation was compared with that of chemical coagulation with ferric sulfate . The results obtained showed that highest removals after electrocoagulation were 71.15, 98.26, and 86.59% for the COD, colour and turbidity respectively. Chemical coagulation reduced the COD up to 83.17%, while colour and turbidity removals were 99.81 and 98.62% respectively. Although chemical coagulation leads to highest percentage removals after treatment, electrocoagulation results in near neutral pH values and also decrease conductivity weakly . By contrast, chemical coagulation increases the acidity of the effluent and its conductivity. Hence with close to neutral pH and weak conductivity values obtained for effluents treated by electrocoagulation, it is inferred that such treated effluents can be recycled. http://dx.doi.org/10.4314/njt.v35i1.29
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
