Abstract
CH 4/H 2-based discharges are attractive for dry etching of single crystal ZnO because of their non-corrosive nature. We show that substitution of C 2H 6 for CH 4 increases the ZnO etch rate by approximately a factor of 2 both with and without any inert gas additive. The C 2H 6/H 2/Ar mixture provides a strong enhancement over pure Ar sputtering, in sharp contrast to the case of CH 4/H 2/Ar. The threshold ion energy for initiating etching is 42.4 eV for C 2H 6/H 2/Ar and 59.8 eV for CH 4/H 2/Ar. The etched surface morphologies were smooth, independent of the chemistry and the Zn/O ratio in the near-surface region was unchanged within experimental error after etching with both chemistries. The plasma etching improved the band-edge photoluminescence intensity and suppressed the deep level emission from the bulk ZnO under our conditions, due possibly to removal of surface contamination layer.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.