Abstract
The objective of this paper is to present the design and implementation of an active vehicle suspension system that aims at reducing vibrations experienced by the driver. Cost effectiveness, ride comfort and robustness are major design parameters in developing the solution. A half car suspension system test rig is constructed for testing the three implemented controllers. Back stepping is used as the primary controller due to its ability to handle non linear systems. The adaptive sliding mode controller is implemented to improve robustness and to deal with non parametric actuation related uncertainties of the controller. A comprehensive comparison of the performance of a back stepping controller was experimented and tested against the proportional integral derivative (PID) and the adaptive sliding back stepping (ASB) controllers in a progressive incremental manner. The experimental results showed that the back stepping, ASB and the PID controllers reduced the sprung mass displacement up to 76.8 %, 71.3 % and 60.9 % respectively when compared to the passive system. The adaptive sliding mode controller performance shows adaptive properties as its performance improves with time. Although ride comfort has been improved, the quality of the suspension travel has been compromised. Matlab, Simulink and DSpace are used for the programming environment.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
