Abstract
Discontinuous long-fibre (DLF) composites can be made with randomly oriented unidirectional pre-impregnated composite chips. High fibre volume fraction unidirectional fibre chips provide good mechanical properties to the DLF composite architecture, which enables this material to contribute to bridging the gap between continuous-fibre and randomly-oriented short-fibre composites. However, it is well known that unidirectional fibres have highly anisotropic in-plane behaviour, which causes weak points in the parts when chips are oriented at unfavourable angles. This can be problematic since chips are randomly oriented in DLF composites. To overcome this problem, this research utilizes woven fibre chips instead of unidirectional fibre chips to fabricate DLF composites. Woven fibres diminish the potential for weak points due to their more homogenized in-plane mechanical properties. For comparison purposes, compression moulded carbon/PEI samples were made from both unidirectional chips and 5HS woven chips. Bending and tensile tests following ASTM guidelines were performed to compare both types of fibre arrangement. The results show that woven fibre chips increase the mechanical properties of the DLF composites and reduce their variability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
