Abstract
Chemical mechanical polishing of copper and tantalum was performed using fumed amorphous silica abrasive particles dispersed in H2O2, Fe(NO3)3, and glycine solutions. Results showed that in DI water silica did not polish Cu but Ta had a relatively high polish rate. Cu polish rate decreased with increasing particle concentration in Fe(NO3)3-based slurries due to the adsorption of Fe3+ on the silica surface. Addition of H2O2 enhanced Cu polish rate but reduced Ta polish rate. The specific surface area of the particles played an important role in the removal of Ta and Cu, presumably due to some chemical bonding between the materials being polished and the silica particles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
