Chemical controls on incipient Mg-silicate crystallization at 25°C: Implications for early and late diagenesis

Abstract

AbstractMg-silicate minerals (e.g., stevensite, kerolite, talc, sepiolite) play an important role in the construction of facies models in lacustrine and peri-marine environments because they are sensitive to changes in solution chemistry. However, the response of Mg-silicate mineralogy to changing aqueous chemistry is only broadly understood because the mechanisms underpinning the coprecipitation of Mg2+and SiO2(aq) from surface water, and subsequent Mg-silicate crystallization, are unclear. Here we describe the results of experiments designed to systematically examine the effects of pH, Mg/Si and salinity of the parent solution on the nature of initially precipitated products. Structural interrogation of the products with X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR) and thermal analysis (TGA/DTA) allow comparison of synthetic products with naturally occurring crystalline counterparts. In general, Mg2+and SiO2(aq) co-precipitation and nucleation of Mg-silicate layer structures first involves the rapid formation of 2:1 layers with trioctahedral occupancy and a mean coherent X-ray scattering domain between 1–2 unit cells with respect to thecaxis. Well defined but diffusehkreflections indicate two-dimensional growth, turbostratic stacking and highly variable interlayer hydration. Diffuse reflectance FTIR shows numerous structural similarities with stevensite, kerolite and sepiolite. However, TGA/DTA analysis indicates the presence of variable kerolite/stevensite interstratification not readily detectable through XRD analyses, as well as a significant degree of surface and interlayer hydration (e.g. 15–20 wt.%).We observe a number of clear trends in the products with respect to solution chemistry. For example, at low salinity, kerolite-like products dominate at high Mg/Si and high pH, whereas sepiolite-like products are formed at lower pH and lower Mg/Si. At high salinity and high Mg/Si, stevensite-like products are favoured at high pH and kerolite-like products dominate at lower pH, whereas a decrease in Mg/Si of the solution leads to sepiolite-like products at low pH and only stevensite-like products at high pH. Higher pH leads to an increase in octahedral vacancies which favour stevensite-like products; this may result from a higher rate of two-dimensional tetrahedral sheet expansion relative to the octahedral sheet, as inferred from studies of silica oligomerization and brucite growth kinetics.Together, our results indicate that the neoformation of Mg-rich silicates from solution may often begin with the rapid nucleation of hydrated 2:1 layers. Subsequent dehydration leads to progressive layer stacking order and could occur in response to wetting/drying cycles, prolonged exposure to high salinity solutions, or burial and heating. The surface and interlayer water associated with these products is undoubtedly an important source of diagenetic water in Mg-silicate-bearing successions, and the chemistry of this water upon later diagenesis should be a focus of future investigation.