Abstract
AbstractIn the frame of the development of very high temperature die material solutions, two grades of alumina based ceramic fibres with a diameter close to 12 μm have been investigated as reinforcement solutions for an andalusite refractory castable. High temperature mechanical tests were performed up to 1200°C in four‐point bending conditions: rupture tests at high temperature and anisothermal creep tests. After testing, microstructural and rupture surface were observed in order to get information on deformation mechanisms and rupture processes. Results show that significant mechanical improvement were obtained up to 1100°C when compared to non reinforced refractory castables.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
