Capturing the experimental behaviour of a point-absorber WEC by simplified numerical models

Abstract

The paper presents a wave basin experiment of a direct-driven point-absorber wave energy converter moving in six degrees of freedom. The goal of the work is to study the dynamics and energy absorption of the wave energy converter, and to verify under which conditions numerical models restricted to heave can capture the behaviour of a point-absorber moving in six degrees of freedom. Several regular and irregular long-crested waves and different damping values of the power take-off system have been tested. We collected data in terms of power output, device motion in six degrees of freedom and wave elevation at different points of the wave basin. A single-body numerical model in the frequency domain and a two-body model in the time domain are used in the study. Motion instabilities due to parametric resonance observed during the experiments are discussed and analysis of the buoy motion in terms of the Mathieu instability is also presented. Our results show that the simplified models can reproduce the body dynamics of the studied converter as long as the transverse non-linear instabilities are not excited, which typically is the case in irregular waves. The performance of the more complex time domain model is able to reproduce both the buoy and PTO dynamics, while the simpler frequency domain model can only reproduce the PTO dynamics for specific cases. Finally, we show that the two-body dynamics of the studied wave energy converter affects the power absorption significantly, and that common assumptions in the numerical models, such as stiff mooring line or that the float moves only in heave, may lead to incorrect predictions for certain sea states.