Abstract
AbstractIntegrated watershed models can be used to calculate streamflow generation in snow‐dominated mountainous catchments. Parameterization of water flow is often complicated by the lack of information on subsurface hydraulic properties. In this study, bulk density optimization was used to determine hydraulic parameters for the upper and lower regolith in the GEOtop model. The methodology was tested in two small catchments in the Dry Creek Watershed in Idaho and the Libby Creek Watershed in Wyoming. Modelling efficiencies for profile‐average soil–water content for the two catchments were between 0.52 and 0.64. Modelling efficiencies for stream discharge (cumulative stream discharge) were 0.45 (0.91) and 0.54 (0.94) for the Idaho and Wyoming catchments, respectively. The calculated hydraulic properties suggest that lateral flow across the upper–lower regolith interface is an important driver of streamflow in both the Idaho and Wyoming watersheds. The overall calibration procedure is computationally efficient because only two bulk density values are optimized. The two‐parameter calibration procedure was complicated by uncertainty in hydraulic conductivity anisotropy. Different upper regolith hydraulic conductivity anisotropy factors had to be tested in order to describe streamflow in both catchments.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
